Pioneer XV-DV131 juhend

Pioneer XV-DV131
7.5 · 1
PDF juhend
 · 2 lehekülge
Inglise
juhendPioneer XV-DV131
AUDIO
IN
R
L
OUT
R
L
SPEAKERSVIDEO
OUT
COMPONENTVIDEO OUTVIDEO
OUT
RL
RL
SUB
WOOFER
CENTERFRONT
SURROUND
VIDEO
LINE
Y
C
B
/
P
B
C
R
/
P
R
Check that you have all the accessories, then put the batteries in the remote control.

Setting up your DVD/CD Receiver

1
1 2
3
Video cordBatteries and remote controlFM antennaAM loop antenna
2
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.
1
2
3
Push open the tabs, then insert one wire fully into each terminal.Release the tabs to secure the AM antenna wires.Pull off the protective shields of both AM antenna wires.
4
Fix the AM loop antenna to the attached stand.To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. A) then clip the loop onto the stand (fig. B).Note: If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. C) before clipping the loop to the stand. Make sure the reception is clear.
5
6
Place the AM antenna on a flat surface and point in the direction giving the best reception. Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.Connect the FM wire antenna to the FM UNBAL 75 antenna terminal.For best results, extend the FM antenna fully and fix to a wall or door frame. Dont drape loosely or leave coiled up. Note: The signal earth (H) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth.
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.
Do not use these speakers with any other system or amplifier as this may result in damage or fire.
3
Connect each speaker using the color-coded speaker plugs. Match them to the colored speaker terminals on the rear panel of the DVD/CD receiver.Connect each speaker as shown below.For the best surround sound, setup your speakers as above. The front left and right speakers should be about 1.8–2.7 m apart.Congratulations! You're done setting up.These speaker terminals can be hazardous when live. When you connect or disconnect the speaker cables, to prevent the risk of electric shock, do not touch uninsulated parts before disconnecting the power cord.Connect the DVD/CD receiver to your TV, then connect the supplied power cord.
3
Connect the power cord to the AC inlet.
2
Connect one end to a video input on your TV.Use the supplied video cord.
4
1
Using the remote controlThe remote control can be used within a range of about 7 meters from the remote sensor on the front panel, and within a 30 degree angle. Precautions: The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote control is not directed towards the remote sensor of the display unit at the correct angle. The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the units remote sensor. The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote controls of other devices which use infrared rays are used. Also, the use of this remote control may cause other devices to work improperly. When the operating range of the remote becomes too short, replace the batteries. Remote control battery cautionIncorrect use of batteries may cause leakage or rupture. Always be sure to follow these guidelines: Always insert batteries into the battery compartment correctly matching the positive ª and negative · polarities, as shown by the display inside the compartment. Never mix new and used batteries. Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries. When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. Additional notes on connecting antennas Keep antenna cables away from the main unit and other cables. To assure optimum reception, pull the FM antenna so that it is fully extended and not coiled or hanging at the rear of the unit. If reception with the supplied antenna is poor, see the Other connections section in the main operating instructions for details on connecting outdoor antennas. Additional notes on speaker placementIf your listening room is of adequate size, place the speakers as shown in step 3 to achieve the optimum surround sound effect. If you are listening in a fairly small room and a typical surround speaker setup is not possible, see Home theater sound setup in the instruction manual and the Speaker Setup Guide for information on the Front Surround 3-spot setup option.When using the standard surround speaker setup as shown in step 3, please observe the following guidelines: Install the main front left and right speakers at an equal distance from the TV. For optimum effect, install the rear speakers slightly above ear level. Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen.Precautions: When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire. The front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens case, turn the power switch of the television set OFF, and turn it ON after 15 to 30 minutes. If the problem persists, place the speaker system away from the television set. The subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to the subwoofer. Do not fix the subwoofer to the wall or ceiling; they could cause injury if they fell.Connect the other end to the video output of the DVD/CD receiver.This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. Printed in <ARE7359-A>Match the color-coded speaker plugs to the colored speaker terminals on the rear of the DVD/CD receiver (as shown at left). Make sure to insert completely.The small lug at the wire-end of the speaker plug should face up or down depending on whether it's being plugged into one of the upper or lower three speaker terminals. Please make sure to connect correctly.Upper three terminalsLower three terminalsPower cordPower cord*Power plug adapter* Illustration shows the Central and South American models
AUDIO
IN
R
L
OUT
R
L
AC IN
SPEAKERS
VIDEO
OUT
COMPONENT
VIDEO OUT
S-VIDEO
OUT
RL
RL
SUB
WOOFER
CENTERFRONT
SURROUND
VIDEO
ANTENNA
FM
UNBAL 75
AM
LOOP ANTENNA
LINE
Y
C
B
/
P
B
C
R
/
P
R
ANTENNA
3
1
2
4
6
fig. A fig. B fig. C
FM
UNBAL 75 AMLOOP ANTENNA
VIDEO
OUT
COMPONENTVIDEO OUTS-VIDEO
OUT
VIDEO
A
Y
C
B
/
P
B
C
R
/
P
R
AC INVIDEO INTo AC outletAUDIO SUBTITLE ANGLE ZOOMSTANDBY/ON MUTEDVD/CDFM/AMTUNER
LINE
SYSTEMSETUP
HOME
MENU
DVD
MENU
TOP
MENU
RETURNTEST TONESOUND
MODE
SHIFTCLEAR SLEEPDISPLAYVOLUME
123
456
78
9
0
TUNE
TUNE
ST
ST
ENTERSURROUND FRONT SURROUNDFront right (Red)Front left(White)Surround left (Blue)Surround right (Grey)Listening positionCenter (Green)Subwoofer (Purple)
Front speakers x 2 Center speaker x 1 Surround speakers x 2
Subwoofer x 1This is a standard multichannel surround sound speaker setup for optimal 5.1 channel home theater sound.
1
Attach the smaller non-skid pads to the base of each of the front speakers and the center speaker. The four large non-skid pads are for the subwoofer (as shown).Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker.
2
Connect the speaker system.Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Place them as shown in the diagram above for optimal surround sound.
3
Secure the speaker wire.After testing for the slack necessary to turn the speaker (see the following step), use the groove provided to secure the speaker wire.Standard surround5-spot setup Non-skid pads (large) x 4 Non-skid pads (small) x 12 Mounting brackets x 4
4
Turn the speakers towards the closest wall, lining the arrows up for optimal Front Surround.
Turn each surround speaker so that the arrow at the base is lined up with the (FRONT SURROUND) arrow on the front
speaker. This is only necessary when you are using the Front Surround mode (MODE ON). See the operating instructions for
more on using Front Surround.This setup is ideal when rear surround speaker placement isn’t possible or you want to avoid running long speaker cables in your listening area.Front surround 3-spot setupFront Surround MODE ONCaution To prevent accidents, make sure the surround speaker is placed securely on top of the front speaker. Please don't the attach speakers to the wall or speaker stands for Front surround 3-spot setup.

Speaker Setup Guide

Check that you have all the speaker accessories.Front speakers Center speakerSubwoofer
2
Connect the speaker system.Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Place them as shown in the diagram above for optimal surround sound.The base of each surround speaker fits into the circular groove on the top of the front speakers as shown.
1
Attach the smaller non-skid pads to the base of each of the front speakers and the center speaker. The four large non-skid pads are for the subwoofer (as shown).Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker.Front speakers Center speakerSubwoofer
3
Switch Front Surround MODE OFF for 5-spot set up.See the operating instructions for more on using Front Surround. Screws(for mounting brackets) x 4S-DV131Please refer to Wall-mounting the front and surround speaker systemin the operating instructions for installation.SubwooferFront leftSurround
left
Listening positionCenterFront rightSurround rightFront leftSurround
left
Listening positionCenterSubwooferFront rightSurround rightXV-DV131_Setup.En.GDR.01.02 05.3.24, 3:34 PM1

Vaadake Pioneer XV-DV131 juhendit tasuta siin. See juhend kuulub kategooriasse kodukinosüsteemid ja seda on hinnanud 1 inimest, kelle keskmine hinnang on 7.5. See juhend on saadaval järgmistes keeltes: Inglise. Kas teil on küsimus toote Pioneer XV-DV131 kohta või vajate abi? Esitage oma küsimus siin

Vajate abi?

Kas teil on küsimus kaubamärgi Pioneer mudeli kohta ja vastust pole juhendis? Esitage oma küsimus siin. Kirjeldage oma probleemi selgelt ja põhjalikult. Mida paremini te probleemi kirjeldate, seda lihtsam on teistel Pioneer omanikel teile head vastust pakkuda.

Küsimuste arv: 0

Üldine
Pioneer
XV-DV131
kodukinosüsteem
Inglise
Kasutusjuhend (PDF)

Te ei leia juhendist oma küsimusele vastust? Te võite leida vastuse oma küsimusele kaubamärgi Pioneer mudeli XV-DV131 kohta allpool.

Kas teie küsimust ei ole loendis? Esitage oma küsimus siin

Tulemused puuduvad